Component Inspection
1.CHECK MIRROR SWITCH & CHANGEOVER SWITCH
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch connector.
3. Check door mirror remote control switch.

Is the inspection result normal?
YES >> Inspection end.
NO >> Replace door mirror remote control switch. Refer to MIR "Removal and Installation".
SYMPTOM DIAGNOSIS
P0890 TCM
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0890
Transmission Control Module
Power Relay Sense Circuit Low
Under the following diagnosis
conditions, the battery voltage
supplied to the TCM is less than
...
Dash side finisher
DASH SIDE FINISHER : Removal and Installation
REMOVAL
Remove front kicking plate. Refer to INT "KICKING PLATE INNER : Removal
and Installation".
Lift up rear end of dash side finisher to disengage metal clip.
: Metal clip
3. Pull back dash sid ...