Nissan Versa (N17): U0415 Vehicle speed

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / Body control system (BCS) / U0415 Vehicle speed

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC U0415 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS "DTC Logic".
  • If DTC U0415 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS "DTC Logic".                   

DTC CONFIRMATION PROCEDURE

1. DTC CONFIRMATION

1. Erase the DTC.

2. Turn ignition switch OFF.

3. Perform Self Diagnostic Result of BCM with CONSULT, after the ignition switch has been turned ON for 2 seconds or more.

Is any DTC detected?

YES >> Refer to BCS "DTC Index".

NO >> Inspection End.

Diagnosis Procedure

1. ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF DIAGNOSTIC RESULT

Perform Self Diagnostic Result of ABS with CONSULT. Refer to BRC "CONSULT Function (ABS)".

Is any DTC detected?

YES >> Perform the trouble diagnosis related to the detected DTC. Refer to BRC "DTC Index".

NO >> GO TO 2.

2. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT

Check ABS actuator and electric unit (control unit) power and ground. Refer to BRC "Diagnosis Procedure".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness or connectors.

3. COMBINATION METER SELF DIAGNOSTIC RESULT

Perform Self Diagnostic Result of METER M&A with CONSULT. Refer to MWI "CONSULT Function".

Is any DTC detected?

YES >> Perform the trouble diagnosis related to the detected DTC. Refer to MWI "DTC Index".

NO >> Refer to GI "Intermittent Incident".

U1010 Control unit (CAN)

DTC Logic DTC DETECTION LOGIC                Diagnosis Procedure 1.REPLACE BCM When DTC "U1010" is detected, replace B ...

Other materials:

Clutch pedal
Inspection and Adjustment 1.   Check to see if the master cylinder rod end moves freely. It should not be bound by the clutch pedal. a. If the rod end does not move freely, remove the rod end and check for deformation or damage on the rod end. Leave the rod end removed ...

Trunk room lamp circuit
Description Controls the trunk room lamp (ground side) to turn the trunk room lamp ON and OFF. Component Function Check CAUTION: Before performing the diagnosis, check that the following is normal. Battery saver output/power supply Trunk room lamp bulb Diagnosis Procedure Regar ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0089