Nissan Versa (N17): Fender protector

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Exterior (EXT) / Fender protector

Exploded View

Exploded View

1. Fender protector 2. J-nut Front

Removal and Installation

REMOVAL

1. Remove under cover. Refer to EXT"Removal and Installation".

2. Remove fender protector screws and clips.

3. Remove fender protector.

INSTALLATION

Installation is in the reverse order of removal.

Cowl top

Exploded View 1. Cowl top cover seal 2. Cowl top cover 3. Air intake cover 4. Cowl cover one-way valve 5. Washer nozzle 6. EPT sealer [3.0 mm (0.118 in)] 7. EPT sealer [3.0 mm (0.118 in)] Clip ...

Roof side molding

Exploded View 1. Roof side molding 2. Roof side molding clip 3. Roof panel 4. Body side outer panel Removal and Installation REMOVAL 1. Release roof side molding clip using a suitable tool ...

Other materials:

Power outlets
Instrument panel Console (if so equipped) The power outlets are for powering electrical accessories such as cellular telephones. The outlets are rated at 12 volt, 120W (10A) maximum. CAUTION The outlet and plug may be hot during or immediately after use. Only certain power outlets ...

Combination switch output circuit
Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM connector and combination switch connector. ...

Nissan Versa (N17): Fender protector

Cowl top

Roof side molding

Other materials:

Categories