Toyota
Nissan Versa
 Sedan Service Manual
Transmission & driveline » Transaxle & transmission (TM) » Precautions
On board diagnosis (OBD) System of CVT and Engine

The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.

CAUTION:

  • Be sure to turn the ignition switch OFF and disconnect the battery cable from the negative terminal before any repair or inspection work. The open/short circuit of related switches, sensors, solenoid valves, etc. will cause the MIL to light up.
  • Be sure to connect and lock the connectors securely after work. A loose (unlocked) connector will cause the MIL to light up due to an open circuit. (Be sure the connector is free from water, grease, dirt, bent terminals, etc.)
  • Be sure to route and secure the harnesses properly after work. Interference of the harness with a bracket, etc. may cause the MIL to light up due to a short circuit.
  • Be sure to connect rubber tubes properly after work. A misconnected or disconnected rubber tube may cause the MIL to light up due to a malfunction of the EGR system or fuel injection system, etc.
  • Be sure to erase the unnecessary malfunction information (repairs completed) from the TCM and ECM before returning the vehicle to the customer.
    More about «Precautions»:

    Precaution for supplemental restraint system (SRS) "Air bag" and "Seat belt pre-tensioner"

    General precautions

    On board diagnosis (OBD) System of CVT and Engine

    Removal and installation procedure for CVT Unit connector

    Nissan Versa Sedan Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Precautions / On board diagnosis (OBD) System of CVT and Engine

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2020 Copyright www.niveguide.com