Nissan Versa (N17): P0890 TCM

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P0890 TCM

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P0890 Transmission Control Module Power Relay Sense Circuit Low Under the following diagnosis conditions, the battery voltage supplied to the TCM is less than 8.4V continuously for 0.2 seconds or more.

- Diagnosis condition

- TCM power supply voltage: More than 11 V

 Harness or connector (TCM power supply circuit is open or shorted.)

DTC REPRODUCTION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Check the first trip DTC.

Is "P0890" detected?

YES >> Go to TM, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK TCM BATTERY VOLTAGE CIRCUIT

  1. Turn the ignition switch ON.
  2. Disconnect the TCM connector.
  3. Disconnect the IPDM E/R connector.
  4. Check the continuity between the TCM harness connector and the IPDM E/R harness connector. 

Is the check result normal?

YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".

NO >> GO TO 2.

2.DETECTION OF MALFUNCTION ITEMS

10 A fuse (#49, IPDM E/R). Refer to PG, "IPDM E/R Terminal Arrangement".

Is the check result normal? YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".

NO >> Repair or replace the malfunctioning parts.

P0863 TCM Communication

Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

P0962 Pressure control solenoid A

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0962 Pressure Control Solenoid "A" Control Circuit Low The followi ...

Other materials:

Clutch pedal
Inspection and Adjustment 1.   Check to see if the master cylinder rod end moves freely. It should not be bound by the clutch pedal. a. If the rod end does not move freely, remove the rod end and check for deformation or damage on the rod end. Leave the rod end removed ...

Fluid cooler & fluid warmer system
FLUID COOLER & FLUID WARMER SYSTEM : System Description CVT FLUID COOLER SCHEMATIC COMPONENT DESCRIPTION CVT Oil Warmer The CVT oil warmer (1) is installed on the front part of transaxle assembly. When engine is started while engine and CVT are cold, engine coolant temperatur ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0158