Nissan Versa (N17): Power window main switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Power window control system (PWC) / Power window main switch

Removal and Installation

REMOVAL

1. Remove main power window and door lock/unlock switch finisher assembly using a suitable tool (A).

Pawl

REMOVAL

2. Disconnect the harness connector from the main power window and door lock/unlock switch.

3. Separate main power window and door lock/unlock switch (1) from main power window and door lock/unlock switch finisher using a suitable tool.

CAUTION: Do not bend back the pawls on the switch finisher too far or breakage may occur.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Rear RH side power window does not operate

Front power window switch

Removal and Installation REMOVAL 1. Remove front power window and door lock/unlock switch (RH) finisher assembly using a suitable tool (A). Pawl 2. Disconnect the harness connector from the f ...

Other materials:

Hood
1. Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly. 2. Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips. 3. Raise the hood 3 . 4. Remove the support rod and insert it into the ...

Maintenance precautions
When performing any inspection or maintenance work on your vehicle, always take care to prevent serious accidental injury to yourself or damage to the vehicle. The following are general precautions which should be closely observed. WARNING Park the vehicle on a level surface, apply the pa ...

Nissan Versa (N17): Power window main switch

Rear RH side power window does not operate

Front power window switch

Other materials:

Categories