The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Manual.
WARNING:
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
- Water soluble dirt:
- Oily dirt:
- Do not use organic solvent such as thinner, benzene, alcohol or gasoline.
- For genuine leather seats, use a genuine leather seat cleaner.
PREPARATION
Special Service Tool
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
SYSTEM DESCRIPTION
COMPONENT PARTS
Component Parts Location
1. BCM 2. Combination switch (lighting and turn signal switch) 3. Combination meter 4. Hazard switch 5. IPDM E/R, Daytime light relays 1 and 2 (if equipped), Front fog lamp relay (if equipped) 6. Stop lamp switch 7. Front combination lamp LH, RH 8. Front fog lamp LH, RH (if equipped) 9. Rear combination lamp LH, RH 10. License plate lamp LH, RH 11. High mounted stop lamp
Component Description
Part name | Description |
BCM | Controls the exterior lighting system. |
Combination meter | - Blinks the turn signal indicator lamp and outputs the turn signal
operating sound with integrated buzzer according to the request
from BCM (via CAN communication). - Turns the tail lamp indicator lamp and high beam indicator lamp ON according to the request from BCM (via CAN communication). |
Combination switch (lighting and turn signal switch) | Refer to BCS "COMBINATION SWITCH READING SYSTEM : System Description" (with Intelligent Key) or BCS "COMBINATION SWITCH READING SYSTEM : System Description" (without Intelligent Key). |
Hazard switch | Hazard flasher request signal is output to the BCM. |
IPDM E/R | Controls the integrated relay, and supplies voltage to the load according to the request from BCM (via CAN communication). |
Stop lamp switch | Stop lamp signal is output to the rear combination lamps and highmounted stop lamp. |
SYSTEM
Removal and Installation REMOVAL 1. Remove the instrument lower panel LH (1). Refer to IP "Removal and Installation". 2. Remove door mirror remote control switch (1) from the instrum ...
HEADLAMP SYSTEM : System Diagram HEADLAMP SYSTEM : System Description LOW BEAM OPERATION When the lighting switch is in 2nd position, the BCM receives input requesting the headlamps to illu ...
P0706 Transmission range sensor A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0706
Transmission Range Sensor
"A" Circuit Range/Performance
The following diagnosis conditions
are met and the position
signal is OFF continuously for
15 ...
Blower motor
Exploded View
1. A/C unit assembly 2. Blower motor 3. Blower fan resistor
Removal and Installation
REMOVAL
Disconnect the negative battery terminal. Refer to PG "Removal and
Installation".
Remove the lower knee protector (LH). Refer to IP "Exploded View".
Remove ...