The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Manual.
WARNING:
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
- Water soluble dirt:
- Oily dirt:
- Do not use organic solvent such as thinner, benzene, alcohol or gasoline.
- For genuine leather seats, use a genuine leather seat cleaner.
PREPARATION
Special Service Tool
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
SYSTEM DESCRIPTION
COMPONENT PARTS
Component Parts Location
1. ABS actuator and electric unit (control unit) 2. Combination meter 3. CVT shift selector (O/D OFF switch) (with CVT) A/T shift selector (O/D OFF switch) (with A/T) 4. Air bag diagnosis sensor unit (view with center console removed) 5. Parking brake switch (view with center console removed) 6. Seat belt buckle switch LH 7. Fuel level sensor unit and fuel pump (view with rear seat and access cover removed) 8. Front door switch LH 9. BCM (view with instrument panel removed) 10. EPS control unit (view with instrument lower panel removed) 11. Brake fluid level switch (view with IPDM E/R removed) 12. ECM (view with IPDM E/R removed) 13. TCM 14. Oil pressure sensor 15. Washer fluid level switch (if equipped)
Component Description
CRUISE CONTROL SYSTEM (CCS) PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as &qu ...
Clutch pedal
Inspection and Adjustment
1. Check to see if the master cylinder rod end moves freely.
It
should not be bound by the clutch pedal.
a. If the rod end does not move freely, remove the rod end and
check for deformation or damage on the rod end. Leave the rod
end removed ...
P0974 Shift solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0974
Shift Solenoid "A" Control Circuit
High
The following diagnosis conditions
are met, and the TCM select
switch ON-OFF solenoid
valve monitor value is OF ...