Exploded View

1. Antenna mast 2. Antenna base
Removal and Installation
REMOVAL
1. Remove the headlining. Refer to INT "Removal and Installation".
2. Disconnect the antenna cable.
3. Remove the antenna base nut.
4. Remove the antenna base from the roof panel.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Tighten the antenna base nut to specifications.
NAVIGATION
MicrophoneRemoval and Installation REMOVAL 1. Remove the microphone (1) from the headlining using a suitable tool. Clip 2. Disconnect the harness connector from microphone and remove. INSTALLATION I ...
Head restraints/headrests
WARNING
Head restraints/headrests supplement
the other vehicle safety systems. They may
provide additional protection against injury
in certain rear end collisions. Adjustable
head restraints/headrests must be
adjusted properly, as specified in this section.
Check the adjustment after someo ...
Gear oil
Inspection
OIL LEAKAGE
Make sure that gear oil is not leaking from transaxle or around it.
OIL LEVEL
Remove filler plug (1) and gasket from transaxle case.
Check the oil level from filler plug hole as shown. CAUTION:
Do not start engine while checking oil level.
Install a new gas ...