Security indicator lamp does not blink when power supply position is other than the ON position.
NOTE:
Conditions of Vehicle (Operating Conditions) Power supply position is other than the ON position.
1.CHECK SECURITY INDICATOR LAMP
Check security indicator lamp.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES >> Check intermittent incident. Refer to GI"Intermittent Incident".
NO >> GO TO 1.
REMOVAL AND INSTALLATION

Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP"Removal and Installation". 2. Release the NATS antenna amp. pawls and remove NATS antenna amp. (1) ...
Service data and specifications
(SDS)
General Specifications
Engine type
HR16DE
Type of clutch control
Hydraulic
Clutch disc
Facing size (Outer dia. × Inner dia. × Thickness)
200 × 140 × 3.1 (7.87 × 5.51 × 0.122)
Recommended clutch fluid
Refer to M ...
Component parts
CVT CONTROL SYSTEM
CVT CONTROL SYSTEM : Component Parts Location
1. IPDM E/R 2. TCM 3. Transmission range switch
4. Primary speed sensor 5. CVT unit 6. Output speed sensor
7. Secondary speed sensor 8. G sensor 9. Stop lamp switch
10. CVT shift selector 11. Overdrive control switch 12. Combi ...