Removal and Installation

1. Steering wheel 2. Steering wheel audio control switches 3. Driver air bag module 4. Steering wheel rear finisher
REMOVAL
1. Remove the steering wheel. Refer to ST "Removal and Installation".
2. Remove the steering wheel rear finisher.
3. Remove the steering wheel audio control switches screws.
4. Remove the steering wheel audio control switches from the steering wheel.
INSTALLATION
Installation is in the reverse order of removal.
MICROPHONE
Removal and Installation
REMOVAL
1. Remove the microphone (1) from the headlining using a suitable tool.
Clip

2. Disconnect the harness connector from microphone and remove.
INSTALLATION
Installation is in the reverse order of removal.
Satellite radio antennaRemoval and Installation REMOVAL 1. Remove the headlining assembly. Refer to INT "Removal and Installation". 2. Disconnect the satellite radio antenna retainers (A) using a suitable to ...

Removal and Installation REMOVAL 1. Remove the combination meter. Refer to MWI "Removal and Installation" (Type A) or MWI"Removal and Installation" (Type B). 2. Remove the A ...
Rear oil seal
REAR OIL SEAL : Removal and Installation
REMOVAL
Remove transaxle assembly.
Remove clutch cover and clutch disk (M/T models).
Remove flywheel (M/T models) or drive plate (A/T or CVT models).
Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage crankshaft an ...
Cooling fan control
Cooling fan control : system diagram
Cooling fan control : system description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Camshaft position sensor (PHASE)
Engine speed*1
Piston position
Cool ...