Description
Diagnosis Procedure
1.CHECK WASHER FLUID LEVEL SWITCH
Perform a unit check for the washer fluid level switch. Refer to MWI "Component Inspection".
Is the inspection result normal?
YES >> GO TO 2
NO >> Replace washer fluid level switch. Refer to WW "Exploded View".
2.CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT
Check the washer fluid level switch signal circuit. Refer to MWI "Diagnosis Procedure".
Is the inspection result normal?
YES >> Replace combination meter. Refer to MWI "Removal and Installation".
NO >> Repair or replace harness or connector.
REMOVAL AND INSTALLATION
The oil pressure warning lamp
does not turn onDescription The oil pressure warning lamp stays of when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK COMBINATION METER OIL PRESSURE WARNING LIGHT 1. Select METER/M&A on CONS ...

Removal and Installation REMOVAL 1. Disconnect the negative battery terminal. Refer to PG "Removal and Installation". 2. Remove cluster lid A. Refer to IP "Removal and Installati ...
Service data and specifications
(SDS)
General Specification
CAUTION:
Use only Genuine NISSAN Matic S ATF. Do not mix with other ATF.
Using ATF other than Genuine NISSAN Matic S ATF will cause
deterioration of driveability and A/T durability, and may damage
the A/T, which is not covered by the warranty.
*1: ...
Front stabilizer
Exploded View
1. Stabilizer bar 2. Stabilizer clamp 3. Stabilizer bushing
4. Stabilizer connecting rod 5. Strut assembly 6. Front suspension member
Front
Removal and Installation
REMOVAL
Remove wheel and tire assemblies using power tool. Refer to WT
"Adjustment".
Remove ...