Nissan Versa (N17): B1209 - B1210 Collision detection

Description

DTC B1209 - B1210 COLLISION DETECTION

The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a frontal or side deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.

PART LOCATION

Refer to SRC "Component Parts Location".

DTC Logic

DTC DETECTION LOGIC

With CONSULT   

CONSULT name

DTC

DTC detecting condition

Repair order

FRONTAL COLLISION DETECTION B1209 Driver and/or front passenger air bag modules are deployed. Refer to SR "For Frontal Collision".
SIDE COLLISION DETECTION B1210 Side and/or curtain air bag modules are deployed. Refer to SR "For Side and Rollover Collision".

DTC CONFIRMATION PROCEDURE (With CONSULT)

1.INSPECTION START

Turn ignition switch ON.

>> GO TO 2.

2.CHECK SELF-DIAG RESULT

Check for the DTC on CONSULT.

Is the DTC detected?

YES >> Refer to SRC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Refer to SR "For Frontal Collision" or SR "For Side and Rollover Collision".

SYMPTOM DIAGNOSIS

B1017, B1018, B1020, B1021, B1022, B1025, B1032, B1048 OCS System

Description DTC B1017, B1018, B1020, B1021, B1022, B1025, B1032, B1048 OCCUPANT CLASSIFICATION SYSTEM (OCS) The OCS control unit is wired to the air bag diagnosis sensor unit. The air bag diag ...

SRS Air bag warning lamp does not turn on

AIR BAG Warning Lamp Does Not Turn On 1.CHECK METER FUSE Check the 10A fuse [No. 3, located in the fuse block (J/B)]. Is the fuse blown? YES >> GO TO 2 NO >> GO TO 3 2.REPLACE METER ...

Other materials:

PLUG
Description Replace the O-ring if oil leakage or exudes from the plug. Exploded View 1. Plug 2. O-ring 3. O-ring 4. Plug Genuine NISSAN CVT Fluid NS-3 Removal and Installation REMOVAL Remove the plugs and O-rings. INSTALLATION Installation is in the reverse order of removal. CAUT ...

Air pressure monitor
AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR) NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display tire pressure ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.014