Nissan Versa (N17): Both doors mirror defogger don't operate but rear window defogger operates

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Defogger (DEF) / Both doors mirror defogger don't operate but rear window defogger operates

Diagnosis Procedure

1. CHECK DOOR MIRROR DEFOGGER FUSE

Check if the following fuse in fuse block (J/B) is blown.

Is the inspection result normal?

YES >> GO TO 2

NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.

2. CHECK BOTH DOOR MIRROR DEFOGGER

1. Check door mirror LH. Refer to DEF "Component Function Check".

2. Check door mirror RH. Refer to DEF "Component Function Check".

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> Repair or replace the malfunctioning parts.

DRIVER SIDE DOOR MIRROR DEFOGGER DOES NOT OPERATE

Diagnosis Procedure

1. CHECK DOOR MIRROR DEFOGGER LH

Check door mirror defogger LH.

Refer to DEF "Component Function Check".

Is the inspection result normal?

YES >> Refer to GI "Intermittent Incident".

NO >> Repair or replace the malfunctioning parts.

PASSENGER SIDE DOOR MIRROR DEFOGGER DOES NOT OPERATE

Diagnosis Procedure

1. CHECK DOOR MIRROR DEFOGGER RH

Check door mirror defogger RH.

Refer to DEF "Component Function Check".

Is the inspection result normal?

YES >> Refer to GI "Intermittent Incident".

NO >> Repair or replace the malfunctioning parts.

REAR WINDOW DEFOGGER SWITCH DOES NOT LIGHT, BUT REAR WINDOW DEFOGGER OPERATES

Diagnosis Procedure

1. CHECK FRONT AIR CONTROL (REAR WINDOW DEFOGGER SWITCH)

Check that the front air control (rear window defogger switch) is operating normally.

Is the inspection result normal?

YES >> Refer to GI "Intermittent Incident".

NO >> Refer to DEF "Diagnosis Procedure".

REMOVAL AND INSTALLATION

Rear window defogger and door mirror defogger do not operate

Diagnosis Procedure 1. CHECK REAR WINDOW DEFOGGER SWITCH Check rear window defogger switch. Refer to DEF "Component Function Check". Is the inspection result normal? YES >> GO ...

Filament

Inspection and Repair INSPECTION 1. When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. 2. Attach probe circuit t ...

Other materials:

Power steering fluid
Check the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 32 to 86ºF (0 to 30ºC). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid ...

P1148 closed loop control
DTC Logic DTC DETECTION LOGIC NOTE: DTC P1148 is displayed with DTC for A/F sensor 1. When the DTC is detected, perform the trouble diagnosis of DTC corresponding to A/F sensor 1. DTC No. Trouble diagnosis (Trouble diagnosis content) DTC detecting condition Possible cause ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.005