Nissan Versa (N17): License plate lamp

Exploded View

Exploded View

1. License plate lamp 2. License plate lamp bulb

Removal and Installation

REMOVAL

1. While pressing the license plate lamp housing pawl toward the right, pull the housing downward and remove.

2. Rotate the bulb socket counterclockwise and remove.

3. Remove the license plate lamp.

INSTALLATION

Installation is in the reverse order of removal.

Bulb Replacement

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION:

  • Disconnect the battery negative terminal or remove power circuit fuse while performing the operation.
  • After installing the bulb, install the back cover and the bulb socket securely for watertightness.
  • Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
  • Do not leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.

LICENSE PLATE LAMP BULB

Removal

1. Remove the license plate lamp. Refer to EXL "Removal and Installation".

2. Remove the bulb from the socket.

Installation

Installation is in the reverse order of removal.

CAUTION: After installing the bulb, install the bulb socket securely for watertightness.

SERVICE DATA AND SPECIFICATIONS (SDS)

Bulb Specifications

Bulb Specifications

*: Always check with the Parts Department for the latest parts information.

High-mounted stop lamp

Exploded View Rear Spoiler 1. Rear spoiler 2. High-mounted stop lamp assembly Rear Parcel Shelf 1. Rear parcel shelf finisher 2. High-mounted stop lamp socket 3. High-mounted stop lamp b ...

Other materials:

EVAP leak check
Inspection CAUTION: Do not use compressed air or a high pressure pump. Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: Do not start engine. Improper installation of EVAP service port adapter [commercial service tool: (J-41413-OBD)] to the EVAP ...

Shift position indicator circuit
Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift the selector lever. Check that the selector lever position and the shift position indicator on the combination meter are identical. Is the inspection result normal? YES >> INSPECTION ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0111