Nissan Versa (N17): Car phone or CB radio

Nissan Versa 2nd generation (N17) Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Car phone or CB radio

When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts.

WARNING

  • A cellular phone should not be used for any purpose while driving so full attention may be given to vehicle operation.

    Some jurisdictions prohibit the use of cellular phones while driving.

  • If you must make a call while your vehicle is in motion, the hands free cellular phone operational mode (if so equipped) is highly recommended. Exercise extreme caution at all times so full attention may be given to vehicle operation.
  • If you are unable to devote full attention to vehicle operation while talking on the phone, pull off the road to a safe location and stop your vehicle.

CAUTION

  • Keep the antenna as far away as possible from the electronic control modules.
  • Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harnesses. Do not route the antenna wire next to any harness.
  • Adjust the antenna standing-wave ratio as recommended by the manufacturer.
  • Connect the ground wire from the CB radio chassis to the body.
  • For additional information, it is recommended that you visit a NISSAN dealer for this service.

NissanConnectSM Mobile Apps (if so equipped)

This vehicle is equipped with Smartphone Integration technology. This allows many compatible Smartphone applications to be displayed and easily controlled through the vehicle's touchscreen. NOTE: ...

Bluetooth Hands-Free Phone System without Navigation System (Type A) (if so equipped)

WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicl ...

Other materials:

Steering wheel
Inspection CHECKING CONDITION OF INSTALLATION Check installation conditions of steering gear assembly, front suspension assembly, axle and steering column assembly. Check if movement exists when steering wheel is moved up and down, to the left and right and to the axial direction. ...

A/C Indicator
Diagnosis Procedure Regarding Wiring Diagram information, refer to HAC "Wiring Diagram" or HAC "Wiring Diagram". 1.CHECK A/C INDICATOR POWER SUPPLY Turn ignition switch ON. Check voltage between front air control harness connector and ground.  Is the inspec ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0062