Nissan Versa (N17): Center pillar upper finisher

Nissan Versa 2nd generation (N17) Service Manual / Body interior / Interior (INT) / Center pillar upper finisher

CENTER PILLAR UPPER FINISHER : Removal and Installation

REMOVAL

  1. Remove front shoulder anchor. Refer to SB "SEAT BELT RETRACTOR : Removal and Installation".
  2. Remove front body side welt and rear body side welt. Refer to INT "BODY SIDE WELT : Removal and Installation".
  3. Release center pillar upper finisher upper pawl using a suitable tool as shown.

WARNING: Do not reuse center pillar upper finisher if removed.

CAUTION: When releasing molded in pawls, follow the steps as shown to prevent finisher or clip damage.

REMOVAL

    4.   Release center pillar upper finisher lower pawl using a suitable tool (A) and remove center pillar upper finisher.

: Pawl

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: When installing center pillar upper finisher, make sure that pawls and are securely pressed into the body panel holes.

Body side welt

BODY SIDE WELT : Removal and Installation CAUTION: Do not excessively pull or stretch body side welts. FRONT BODY SIDE WELT Removal Remove dash side finisher. Refer to INT "DASH SIDE FI ...

Rear pillar finisher

REAR PILLAR FINISHER : Removal and Installation REMOVAL Partially remove rear body side welt. Refer to INT "BODY SIDE WELT : Removal and Installation". Remove rear seat cushion. Re ...

Other materials:

Bluetooth Hands-Free Phone System with Navigation System (if so equipped)
WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. If you are unable to devote full attention to vehicle operation while talking on ...

P0732 2GR Incorrect ratio
Description This malfunction is detected when the A/T does not shift into 2GR position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc. DTC ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.006