WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION: Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
REMOVAL
1. Remove the center console assembly. Refer to IP "Removal and Installation".
2. Rotate shift selector lamp assembly (1) counter-clockwise and remove.
Front

INSTALLATION
Installation is in the reverse order of removal.
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION:
SHIFT SELECTOR LAMP BULB
Removal
1. Remove shift selector lamp. Refer to IP "Removal and Installation".
2. Pull shift selector bulb from bulb socket (1).
Front

Installation
Installation is in the reverse order of removal.

Exploded View 1. Trunk room lamp 2. Bulb Front Pawl ...
Hood
1. Pull the hood lock release handle 1 located
below the instrument panel until the hood
springs up slightly.
2. Locate the lever 2 in between the hood and
grille and push the lever sideways with your
fingertips.
3. Raise the hood 3 .
4. Remove the support rod and insert it into the
...
Throttle valve closed position
learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time harness connector
of electric throttle control actuator or ECM is discon ...