When replacing the TCM, perform the following work.
CHECK LOADING OF CALIBRATION DATA
CALIBRATION OF G SENSOR
CAUTION: When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and then replace TCM.
If the TCM is replaced in advance, perform "ADDITIONAL SERVICE WHEN REPLACING TRANSAXLE ASSEMBLY" after "G sensor calibration".
1.CHECK WORK CONTENTS
Replacing only the TCM>>GO TO 2.
Replacing the TCM after the transaxle assembly is replaced>>GO TO 2.
Replacing the transaxle assembly after the TCM is replaced>>GO TO 5.
2.LOADING OF CALIBRATION DATA
NOTE: Displayed approximately 4 - 5 seconds after the selector lever is moved to the "P" position.
Does the shift position indicator display "P"?
YES >> GO TO 3.
NO >> GO TO 4.
3.PERFORM G SENSOR CALIBRATION
Refer to TM "Work Procedure".
>> WORK END
4.DETECT MALFUNCTIONING ITEM
Check the following items:
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
5.PERFORM G SENSOR CALIBRATION
Refer to TM "Work Procedure".
>> Perform "ADDITIONAL SERVICE WHEN REPLACING TRANSAXLE ASSEMBLY" after "CALIBRATION OF G SENSOR". Refer to TM "Work Procedure".
Break-in schedule
CAUTION
During the first 1,200 miles (2,000 km),
follow these recommendations to obtain
maximum engine performance and ensure
the future reliability and economy of your
new vehicle. Failure to follow these recommendations
may result in shortened
engine life and reduced engine
performance.
...
EVAP control system pressure sensor
Exploded View
1. EVAP control system pressure sensor 2. O-ring 3. EVAP canister
Removal and Installation
NOTE:
The EVAP canister system pressure sensor can be removed without removing the
EVAP canister.
REMOVAL
Remove the EVAP canister protector cover.
Disconnect EVAP canister purg ...