Nissan Versa (N17): Security indicator lamp does not turn on or blink

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / Security indicator lamp does not turn on or blink

Description

Security indicator lamp does not blink when power supply position is other than the ON position.

NOTE:

Before performing the diagnosis, perform "Work Flow". Refer to SEC "Work Flow".
Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis, and check each symptom.

Conditions of Vehicle (Operating Conditions) Power supply position is other than the ON position.

Diagnosis Procedure

1.CHECK SECURITY INDICATOR LAMP

Check security indicator lamp.

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal?

YES >> Check intermittent incident. Refer to GI"Intermittent Incident".

NO >> GO TO 1.

REMOVAL AND INSTALLATION

Engine does not start when intelligent key is inside of vehicle

NATS antenna AMP

Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP"Removal and Installation". 2. Release the NATS antenna amp. pawls and remove NATS antenna amp. (1) ...

Other materials:

P2859 Clutch A pressure
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P2859 Clutch A pressuren disengagement performance The detection conditions continuously for 200 msec or more under the following diagnosis conditions:- Diagnosi ...