Nissan Versa (N17): Security control system (SEC)
Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC)
WITH INTELLIGENT KEY SYSTEM
- Precautions
- Component parts Component parts Component parts
- Intelligent key system/engine start function
- Nissan anti-theft system
- Vehicle security system
- Diagnosis system (BCM)
- Diagnosis and repair work flow
- Additional service when replacing control unit
- P1610 Lock mode
- P1611 ID Discord, IMMU-ECM
- P1612 Chain of ECM-IMMU
- B2192 ID discord, IMMU-ECM
- B2193 Chain of ECM-IMMU
- B2195 Anti-scanning
- B2196 Dongle unit
- B2198 NATS antenna AMP
- B2555 Stop lamp
- B2556 Push-button ignition switch
- B2557 Vehicle speed
- B2601 Shift position
- B2602 Shift position
- B2603 Shift position
- B2604 Shift position
- B2605 Shift position
- B2608 Starter relay
- B260F Engine status
- B26F3 Starter control relay
- B26F4 Starter control relay
- B26F7 BCM
- B26FC Key registration
- B210B Starter control relay
- B210C Starter control relay
- B210D Starter relay
- B210E Starter relay
- B210F Shift position/clutch interlock switch
- B2110 Shift position/clutch interlock switch
- Engine does not start when intelligent key is inside of vehicle
- Security indicator lamp does not turn on or blink
- NATS antenna AMP
- Push-button ignition switch
- Remote keyless entry receiver
- Precautions
- Nissan vehicle immobilizer system-NATS
- Diagnosis system (IPDM E/R)
- Diagnosis and repair workflow
- Inspection and adjustment
- U1000 CAN Comm
- U1010 Control unit (CAN)
- P1610 Lock mode
- B2190, P1614 NATS antenna AMP
- B2191, P1615 Difference of key
- B2192, P1611 ID discord, IMMU-ECM
- B2193, P1612 Chain of ECM-IMMU
- B2195 Anti-scanning
- B2196 Dongle unit
- Power supply and ground circuit
- Vehicle security indicator
- Nissan vehicle immobilizer systemnats symptoms
- NATS antenna AMP
Door & lock (DLK)
WITH INTELLIGENT KEY SYSTEM ...
Other materials:
Drive belt idler pulley
Exploded View
1. Generator bracket 2. Center shaft 3. Spacer
4. Adjusting bolt 5. Washer 6. Idler pulley
7. Plate
Removal and Installation
REMOVAL
Remove the fender protector (RH).
Remove the air duct inlet assembly.
Remove drive belt.
Remove the lock nut, and then remove the pl ...
Engine oil
Inspection
ENGINE OIL LEVEL
Park vehicle on a level surface, wait 10 minutes before checking the
engine oil level.
Pull out oil level gauge and wipe it clean.
Insert oil level gauge and make sure the engine oil level is within
the range (A) as shown.
If it is out of range, adjust it. ...
Categories
- Manuals Home
- Nissan Versa Owners Manual
- Nissan Versa Service Manual
- Video Guides
- Questions & Answers
- External Resources
- Latest Updates
- Most Popular
- Sitemap
- Search the site
- Privacy Policy
- Contact Us
© 2017-2026 Copyright www.niveguide.com
0.0068
0.0068