Nissan Versa (N17): B2192, P1611 ID discord, IMMU-ECM

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B2192, P1611 ID discord, IMMU-ECM

Description

BCM performs the ID verification with ECM that allows the engine to start. BCM starts the communication with ECM if ignition switch is turned ON and starts the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC B2192 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC "DTC Logic".
  • If DTC B2192 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check "Self diagnostic result" with CONSULT.

Is DTC detected?

YES >> Refer to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization with CONSULT. Re-register all mechanical keys.

For initialization and registration of mechanical key, refer to CONSULT Immobilizer mode and follow the onscreen instructions.

Can the system be initialized and can the engine be started with re-registered mechanical key?

YES >> ID was unregistered.

NO >> GO TO 2

2.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization with CONSULT. Re-register all mechanical keys.

For initialization and registration of mechanical key, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

Can the system be initialized and can the engine be started with re-registered mechanical key?

YES >> BCM is malfunctioning.

NO >> GO TO 3

3.REPLACE ECM

1. Replace ECM. Refer to EC "Removal and Installation".

2. Perform initialization with CONSULT. Re-register all mechanical keys.

For initialization and registration of mechanical key, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

Can the system be initialized and can the engine be started with re-registered mechanical key?

YES >> ECM is malfunctioning.

NO >> GO TO 4

4.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

B2191, P1615 Difference of key

Description Performs ID verification through BCM when mechanical key is inserted in the ignition key cylinder. Prohibits the release of steering lock or start of engine when an unregistered ...

B2193, P1612 Chain of ECM-IMMU

Description BCM performs the ID verification with ECM that allows the engine to start. BCM starts the communication with ECM if ignition switch is turned ON and starts the engine if the ID is OK. ...

Other materials:

Power supply and ground circuit
Diagnosis Procedure 1.CHECK GROUND CONNECTION Turn ignition switch OFF. Check ground connection E. Refer to Ground Inspection in GI, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace ground connection. 2.CHECK ECM G ...

Fuel level sensor unit
Disassembly and Assembly Fuel Level Sender Unit 1. Harness connectors 2. Level sending unit module 3. Fuel temperature sensor 4. Float arm assembly Disassembly NOTE: Before disassembly, note the proper placement of the wires to the correct terminals and correct wire routing to the term ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0053