Nissan Versa (N17): B2193, P1612 Chain of ECM-IMMU

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B2193, P1612 Chain of ECM-IMMU

Description

BCM performs the ID verification with ECM that allows the engine to start. BCM starts the communication with ECM if ignition switch is turned ON and starts the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC "DTC Logic".
  • If DTC B2193 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC "Diagnosis Procedure".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check "Self diagnostic result" with CONSULT.

Is DTC detected?

YES >> Refer to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization with CONSULT.

For initialization, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

Does the engine start?

YES >> Inspection End.

NO >> ECM is malfunctioning.

  • Replace ECM.
  • Perform ECM re-communicating function.

B2192, P1611 ID discord, IMMU-ECM

Description BCM performs the ID verification with ECM that allows the engine to start. BCM starts the communication with ECM if ignition switch is turned ON and starts the engine if the ID is OK ...

Other materials:

Component parts
Component Parts Location 1 ABS actuator and electric unit (control unit) 2 IPDM E/R 3 Brake fluid level switch (view with IPDM E/R removed) 4 Front wheel sensor 5 Rear wheel sensor 6 VDC OFF switch 7 Steering angle sensor (view with steering wheel and spiral cable removed) 8 Stop lamp ...

EPS Warning lamp does not turn OFF
Description EPS warning lamp does not turn OFF several seconds after engine started. Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT Turn the ignition switch OFF to ON. Perform "EPS" self-diagnosis. Is any DTC detected? YES >> Check the DTC. Refer to STC "DTC Inde ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0057