Nissan Versa (N17): B26F7 BCM

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B26F7 BCM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press door request switch.

2. Turn ignition switch ON.

3. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select Self Diagnostic Result mode of BCM using CONSULT.

3. Touch ERASE.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B26F7. Refer to SEC "DTC Logic".

Is DTC B26F7 detected again?

YES >> GO TO 2.

NO >> Inspection End.

2.REPLACE BCM

1. Replace BCM. Refer to BCS"Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

>> Inspection End.

Other materials:

Glove box assembly and housing
Removal and Installation REMOVAL 1. Remove glove box lid. a. Open glove box lid. b. Pull glove box lid rearward and glove box lid hinges down and rearward to disengage, then remove the glove box lid. c. Disconnect glove box damper (if equipped). ...

Inside handle
INSIDE HANDLE : Removal and Installation REMOVAL 1. Remove rear door finisher. Refer to INT "Removal and Installation". 2. Remove upper side of sealing screen. NOTE: Cut the butyl tape so that some parts of the butyl tape remain on the sealing screen, if the sealing screen is reuse ...

Nissan Versa (N17): B26F7 BCM

DTC Logic

Diagnosis Procedure

B26F4 Starter control relay

B26FC Key registration

Other materials:

Categories