Nissan Versa (N17): Remote keyless entry receiver

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / Remote keyless entry receiver

Removal and Installation

REMOVAL

1. Remove the glove box. Refer to IP "Removal and Installation".

2. Remove the remote keyless entry receiver bolt (A).

3. Disconnect the harness connector from remote keyless entry receiver and remove remote keyless entry receiver (1)

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

WITHOUT INTELLIGENT KEY SYSTEM

Push-button ignition switch

Removal and Installation REMOVAL 1. Remove NATS antenna amp. Refer to SEC "Removal and Installation". 2. Release the push-button ignition switch pawls and remove the push-button ignition ...

Other materials:

Preparation
Special Service Tools The actual shapes of KentMoore tools may differ from those of special service tools illustrated here. Tool number (KentMoore No.) Tool name Description KV10111100 (J37228) Seal cutter   Removing oil pan (lower and upper) etc. ...

U0073 Communication bus a off
DTC Logic DTC Trouble diagnosis name DTC detecting condition Possible causes U0073 Control Module Communication Bus "A" Off When the ignition switch is ON, TCM detects a bus-off error continuously for 2 seconds or more. Harness or connector (CA ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0071