Nissan Versa (N17): NATS antenna AMP

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / NATS antenna AMP

Removal and Installation

NOTE:

  • If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELFDIAG RESULTS" on CONSULT screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY".
  • Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.

REMOVAL

1. Disconnect the battery negative terminal. Refer to PG "Removal and Installation".

2. Remove the instrument lower panel LH. Refer to IP "Removal and Installation".

3. Remove the NATS antenna amp bolt (A).

4. Disconnect the harness connector (1) from the NATS antenna amp. (2) and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Nissan vehicle immobilizer systemnats symptoms

Symptom Table NOTE: Before performing the diagnosis in the following table, check "SEC "Work Flow"". Check that vehicle is under the condition shown in "Conditions of vehicle" ...

Other materials:

P1212 TCS communication line
Description This CAN communication line is used to control the smooth engine operation during the TCS operation. Pulse signals are exchanged between ECM and "ABS actuator and electric unit (control unit)". Be sure to erase the malfunction information such as DTC not only for "ABS actuat ...

P072D Stuck in 2GR
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072D Stuck in Gear 2 The following diagnosis conditions are met and the detection conditions continue for 0.5 seconds or more.- Diagnosis condition - Shiftin ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0072