DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSIS RESULTS
Check the self-diagnosis results.

Is above displayed on the self-diagnosis display?
YES >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
CAUTION: Replace ABS actuator and electric unit (control unit) when self diagnostic result shows items other than those applicable.
>> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation".
Additional service when replacing
ECM
Description
When replacing ECM, the following procedure must be performed.
PROGRAMMING OPERATION
NOTE:
After replacing with a blank ECM, programming is required to write ECM
information. Be sure to follow the procedure
to perform the programming.
Work Procedure
1.CHECK ECM PART NUMBER
Che ...
A/C On signal
Component Function Check
1.CHECK A/C ON SIGNAL
With CONSULT
Turn ignition switch ON.
Operate front blower motor.
Select "AIR CONDITIONER" of "BCM" using CONSULT.
Select "AIR COND SW" in "DATA MONITOR" mode, and check status under the
following condition.
Is t ...