Nissan Versa (N17): Battery saver output/power supply circuit

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Interior lighting system (INL) / Battery saver output/power supply circuit

Description

Provides the battery saver output/power supply. Also cuts the power supply when the interior lamp battery saver is activated.

Component Function Check

1.CHECK BATTERY SAVER OUTPUT/POWER SUPPLY FUNCTION

CONSULT

1. Turn ignition switch ON.

2. Turn each interior lamp to the ON position.

  • Interior room lamp
  • Map lamp (if equipped)
  • Trunk room lamp

3. Select BATTERY SAVER of BCM (BATTERY SAVER) active test item.

4. While operating the test item, check that each interior room lamp turns ON/OFF.

OFF : Interior room lamp OFF

ON : Interior room lamp ON

Is the inspection result normal?

YES >> Battery saver output/power supply circuit is normal.

NO >> Refer to INL "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to INL "Wiring Diagram".

1.CHECK BATTERY SAVER OUTPUT/POWER SUPPLY OUTPUT

CONSULT

1. Turn ignition switch ON.

2. Select BATTERY SAVER of BCM (BATTERY SAVER) active test item.

3. While operating the test item, check voltage between BCM connector and ground.

Is the inspection result normal?

YES >> GO TO 2.

NO >> Replace BCM after making sure battery saver output/power supply circuit is not shorted to voltage.

Refer to BCS "Removal and Installation" (with Intelligent Key) or BCS "Removal and Installation" (without Intelligent Key).

2.CHECK BATTERY SAVER OUTPUT/POWER SUPPLY OPEN CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect the following connectors.

  • BCM
  • Interior room lamp
  • Map lamp (if equipped)
  • Trunk room lamp

3. Check continuity between BCM connector and each interior lamp connector.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace the harness or connector.

3.CHECK BATTERY SAVER OUTPUT/POWER SUPPLY SHORT CIRCUIT

Check continuity between BCM connector and ground.

Is the inspection result normal?

YES >> Check that each interior room lamp has no internal short circuit.

NO >> Repair or replace the harness or connector.

Interior room lamp control circuit

Description Controls each interior room lamp (ground side) by PWM signal. NOTE: PWM signal control period is approximately 250 Hz (in the gradual brightening/dimming). ...

Other materials:

Starting the engine (models with NISSAN Intelligent Key system)
1. Apply the parking brake. 2. Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The starter is designed not to operate if the shift lever is in any of the driving positions. 3. Push the ignition switch to the ON position. Depress the brake pedal and push the ...

Shift change control
Shift change control : system diagram Shift change control : system description The clutch is controlled with the optimum timing and oil pressure by the engine speed, engine torque information, etc. Shift Change System Diagram *1: Full phase real-time feedback control monitors m ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0081