DTC DETECTION LOGIC
NOTE:
This diagnosis indicates the former, to detect open or short circuit malfunction.
| DTC No. | Trouble diagnosis name | DTC detecting condition | Possible cause |
| P0462 | FUEL LEVEL SEN/CIRC (Fuel level sensor circuit low input) | An excessively low voltage from the sensor is sent to ECM. |
|
| P0463 | FUEL LEVEL SEN/CIRC (Fuel level sensor circuit high input) | An excessively high voltage from the sensor is sent to ECM. |
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is between 11 V and 16 V at ignition switch ON.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
Is 1st trip DTC detected?
YES >> Proceed to EC, "Diagnosis Procedure".
NO >> INSPECTION END
1.CHECK COMBINATION METER FUNCTION
Refer to MWI, "CONSULT Function" (TYPE A) or MWI, "CONSULT Function" (TYPE B).
Is the inspection result normal?
YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".
NO >> Refer to MWI, "Component Function Check" (TYPE A) or MWI, "Component Function Check" (TYPE B). Check the vehicle type to confirm the service information in MWI section. Refer to MWI, "Information".

Description The vehicle speed signal is sent to the combination meter from the "ABS actuator and electric unit (control unit)" by CAN communication line. The combination meter then sends a signal ...
NISSAN Intelligent Key (if so equipped)
WARNING
Radio waves could adversely affect
electric medical equipment. Those who
use a pacemaker should contact the
electric medical equipment manufacturer
for the possible influences before
use.
The Intelligent Key transmits radio
waves when the buttons are pressed.
The FAA ad ...
Line pressure control
Line pressure control : system diagram
Line pressure control : system description
When an engine and A/T integrated control signal (engine torque)
equivalent to the engine drive force is
transmitted from the ECM to the TCM, the TCM controls the line pressure
solenoid valve.
Th ...