Exploded View

1. Piston rod lock nut 2. Washer 3. Bushing 4. Distance tube 5. Bound bumper cover 6. Bound bumper 7. Shock absorber assembly 8. Rear suspension beam
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.


INSPECTION AFTER REMOVAL
Shock Absorber
Check the following items, and replace the part if necessary.
Bound Bumper, Bushing
Check for cracks and damage. Replace it if necessary.
Washer, Bound Bumper Cover, Distance Tube
INSPECTION AFTER INSTALLATION
Check wheel alignment. Refer to RSU "Inspection".
) from top
as shown to release gas gradually.CAUTION:
NOTE:
(A) : 20 - 30 mm (0.79 - 1.18 in)

3. Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION: Dispose of drained oil according to the law and local regulations.
Wheel alignmentInspection DESCRIPTION CAUTION: The adjustment mechanisms of camber and toe-in are not included. If camber and toe-in is outside the standard, check front suspension parts for wear and dama ...

Exploded View 1. Upper rubber seat 2. Coil spring 3. Lower rubber seat 4. Rear suspension beam Removal and Installation REMOVAL Remove the wheel and tire assemblies using power tool. Refe ...
U0300 Can communication data
Description
The amount of data transmitted from each control unit is read.
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
U0300
Internal Control Module Software
Incompatibility
When the amount of data transmitt ...
Brake caliper assembly
BRAKE CALIPER ASSEMBLY : Exploded View
REMOVAL
1. Brake caliper assembly
DISASSEMBLY
1. Cap 2. Bleeder valve 3. Cylinder body
4. Piston seal 5. Piston 6. Piston boot
7. Sliding pin 8. Sliding pin boot 9. Bushing
10. Torque member Apply rubber
grease Apply brake fluid
NOTE:
LH front ...