NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
Is DTC "C1716", "C1717", "C1718", or "C1719" detected?
YES >> Proceed to WT "Diagnosis Procedure".
NO >> Inspection End.
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
1.CHECK TIRE PRESSURE
Check the air pressure of all wheels. Refer to pressure observed during "DTC CONFIRMATION PROCEDURE".
Is the inspection result normal?
YES >> Replace the DTC-detected malfunctioning transmitter. Refer to WT "Removal and Installation".
NO >> GO TO 2.
2.CHECK TIRE PRESSURE SIGNAL
With CONSULT
Are tire pressures displayed as 438.6 kPa (4.47 kg/cm2, 63.6 psi)?
YES >> Replace transmitter for the tire that displayed pressure as 438.6 kPa (4.47 kg/cm2, 63.6 psi).
Refer to WT "Removal and Installation".
NO >> Perform "DTC CONFIRMATION PROCEDURE" again. Refer to WT "DTC Logic".
Windshield-washer fluid
Windshield-washer fluid reservoir
Add a washer solvent to the windshield-washer
fluid reservoir for better cleaning. In the winter
season, add a windshield-washer antifreeze. Follow
the manufacturer's instructions for the mixture
ratio.
Refill the reservoir more frequently when driving
...
S connector circuit
Description
The starter motor magnetic switch is supplied with power when the ignition
switch is turned to the START position
while the selector lever is in the P (Park) or N (Neutral) position.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to STR, "Wiring Diagram - Wit ...