Nissan Versa (N17): C1144 Incomplete steering angle sensor adjustment

Nissan Versa 2nd generation (N17) Service Manual / Brakes / Brake control system (BRC) / C1144 Incomplete steering angle sensor adjustment

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

Turn ignition switch ON.
Perform self diagnostic result.

Is DTC C1144 detected?

YES >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR

Perform neutral position adjustment of steering angle sensor. Refer to BRC "Work Procedure".

>> GO TO 2.

2.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

Perform self diagnostic result.

Is DTC C1144 detected?

YES >> GO TO 3.

NO >> Inspection End.

3.CHECK STEERING ANGLE SENSOR SYSTEM

Check steering angle sensor system. Refer to BRC"Diagnosis Procedure".

Is the inspection result normal?

YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation".

NO >> Repair or replace malfunctioning components.

C1143 Steering angle sensor

C1145, C1146 Yaw rate/side/decel g sensor

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF DIAGNOSTIC RESULT With CONSULT. Turn ignition switch OFF to ON. Perform self diagnostic result. Is ...

Other materials:

Security systems (if so equipped)
Your vehicle has one type of security systems: NISSAN Vehicle Immobilizer System NISSAN vehicle immobilizer system The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for ex ...