FRONT PILLAR FINISHER : Removal and Installation
REMOVAL
: Clip

3. Remove the front pillar finisher clips (B) using a suitable tool (A).

INSTALLATION
1. Install the front pillar finisher clips (A) to the front pillar finisher by inserting clip end and rotating 90 degrees in either direction.

2. Install the front pillar finisher to the front pillar.
CAUTION: When installing front pillar finisher, check that all clips are securely pressed into body panel holes.
Rear door finisherExploded View 1. Rear door panel 2. Rear door finisher 3. Rear power window switch finisher (if equipped) 4. Grommet Clip Metal clip Pawl Removal and Installation REMOVAL Fully open r ...

KICKING PLATE INNER : Removal and Installation FRONT KICKING PLATE Removal 1. Release front kicking plate pawls using a suitable tool (A) and remove front kicking ...
Starting the engine (models with NISSAN Intelligent Key system)
1. Apply the parking brake.
2. Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The starter is designed not to operate if
the shift lever is in any of the driving
positions.
3. Push the ignition switch to the ON position.
Depress the brake pedal and push the ...
Drive belt idler pulley
Exploded View
1. Generator bracket 2. Center shaft 3. Spacer
4. Adjusting bolt 5. Washer 6. Idler pulley
7. Plate
Removal and Installation
REMOVAL
Remove the fender protector (RH).
Remove the air duct inlet assembly.
Remove drive belt.
Remove the lock nut, and then remove the pl ...