Nissan Versa (N17): Key warning lamp

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Key warning lamp

Component Function Check

1.CHECK FUNCTION

Select INTELLIGENT KEY of BCM using CONSULT.
Select INDICATOR in ACTIVE TEST mode.
Touch KEY IND or KEY ON to check that it works normally.

Is the inspection result normal?

YES >> Key warning lamp is OK.

NO >> Refer to DLK "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK KEY WARNING LAMP

Refer to MWI "Work Flow".

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace harness.

2.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

Other materials:

Drive belt idler pulley
Exploded View 1. Generator bracket 2. Center shaft 3. Spacer 4. Adjusting bolt 5. Washer 6. Idler pulley 7. Plate Removal and Installation REMOVAL Remove the fender protector (RH). Remove the air duct inlet assembly. Remove drive belt. Remove the lock nut, and then remove the pl ...

Headlamp (LO) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the BCM via the CAN communication lines. When the headlamp low relay is energized, power flows through fuses 40 and 41, located in the IPDM E/R. (Without dayti ...

Nissan Versa (N17): Key warning lamp

Intelligent key

Remote keyless entry receiver

Other materials:

Categories