Nissan Versa (N17): Keyfob ID set up without consult

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Keyfob ID set up without consult

ID Code Entry Procedure

KEYFOB ID SET UP WITHOUT CONSULT

KEYFOB ID SET UP WITHOUT CONSULT

NOTE:

  • If a keyfob is lost, the ID code of the lost keyfob must be erased to prevent unauthorized use. A specific ID code can be erased with CONSULT. However, when the ID code of a lost keyfob is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new keyfobs must be re-registered.

    To erase all ID codes in memory, register one ID code (keyfob) five times. After all ID codes are erased, the ID codes of all remaining and/or new keyfobs must be re-registered.

  • When registering an additional keyfob, the existing ID codes in memory may or may not be erased. If five ID codes are stored in memory, when an additional code is registered, only the oldest code is erased. If less than five ID codes are stored in memory, when an additional ID code is registered, the new ID code is added and no ID codes are erased.
  • If you need to activate more than two additional new keyfobs, repeat the procedure "Additional ID code entry" for each new keyfob DLK "ID Code Entry Procedure" (with CONSULT), DLK "ID Code Entry Procedure" (without CONSULT).
  • A maximum amount of five ID codes is allowed. When more than five ID codes are entered, the oldest ID code will be erased.
  • Even if same ID code that is already in the memory is input, the same ID code can be entered. The code is counted as an additional code.

SYMPTOM DIAGNOSIS

Keyfob ID set up with consult

ID Code Entry Procedure KEYFOB ID SET UP WITH CONSULT NOTE: If a keyfob is lost, the ID code of the lost keyfob must be erased to prevent unauthorized use. A specific ID code can be erase ...

Power door lock system symptoms

Symptom Table DOOR LOCK/UNLOCK FUNCTION MALFUNCTION NOTE: Before performing the diagnosis in the following table, check "WORK FLOW". Refer to DLK "Work Flow". Check that vehicle ...

Other materials:

Maintenance under severe operating conditions
The maintenance intervals shown on the preceding pages are for normal operating conditions. If the vehicle is mainly operated under severe driving conditions as shown below, more frequent maintenance must be performed on the following items as shown in the table. Severe driving conditions ...

Stall test
Work Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU "Inspection". Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80C (122 to 176F). Inspect the amount of ATF. Replenish ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0065