Nissan Versa (N17): Malfunction indicator lamp

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / Malfunction indicator lamp

Component Function Check

1.CHECK MIL FUNCTION

  1. Turn ignition switch ON.
  2. Make sure that MIL lights up.

Is the inspection result normal?

YES >> INSPECTION END

NO >> Go to EC, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX is not displayed.

Is DTC detected?

YES >> Perform trouble diagnosis for DTC UXXXX.

NO >> GO TO 2.

2.CHECK COMBINATION METER

Check DTC with combination meter. Refer to MWI, "DTC Index" (TYPE A) or MWI, "DTC Index" (TYPE B).

Is DTC detected?

YES >> Perform troubleshooting relevant to DTC indicated.

NO >> GO TO 3.

3.CHECK INTERMITTENT INCIDENT

Refer to GI, "Intermittent Incident".

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI, "Removal and Installation" (TYPE A) or MWI, "Removal and Installation" (TYPE B). Check the vehicle type to confirm the service information in MWI section. Refer to MWI, "Information".

NO >> Repair or replace harness or connectors.

Ignition signal

On board refueling vapor recovery (ORVR)

Component Function Check 1.CHECK ORVR FUNCTION Check whether the following symptoms are present. Fuel odor from EVAP canister is strong. Cannot refuel/Fuel odor from the fuel filler opening i ...

Other materials:

P062F EEPROM
Description TCM checks the value read in FLASH ROM at ignition switch ON, and judges if there is writing failure to FLASH ROM or malfunction of FLASH ROM. DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P062F Inter ...

G Sensor
Exploded View 1. G sensor  Front Removal and Installation CAUTION: Do not drop or strike G sensor, because it may be damaged by impact. Do not use a power tool. REMOVAL Disconnect the battery negative terminal. Refer to PG "Removal and Installation". Remov ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0112