DTC DETECTION LOGIC
NOTE: If DTC P0520 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC, "DTC Logic".
DTC No. | Trouble diagnosis (Trouble diagnosis content) | Detecting condition | Possible cause |
P0520 |
EOP SENSOR/SWITCH [Engine oil pressure sensor circuit] | ECM detects the following status continuously for
5 seconds or more:
|
|
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
>> GO TO 2.
2.CHECK ENGINE OIL LEVEL
Check engine oil level. Refer to LU, "Inspection".
Is inspection result normal?
YES >> GO TO 3.
NO >> Check engine oil leak. Refer to LU, "Inspection".
3.PERFORM DTC CONFIRMATION PROCEDURE
Is 1st trip DTC detected?
YES >> Proceed to EC, "Diagnosis Procedure".
NO >> INSPECTION END
1.CHECK ENGINE OIL PRESSURE SENSOR POWER SUPPLY CIRCUIT
Is inspection result normal?
YES >> GO TO 2
NO >> Repair or replace error-detected parts.
2.CHECK ENGINE OIL PRESSURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
1. Check the continuity between engine oil
pressure sensor harness connector and ECM harness connector.
2. Also check harness for short to ground and short to power.
Is inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace error-detected parts.
3.CHECK ENGINE OIL PRESSURE SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Check the continuity between engine oil
pressure sensor harness connector and ECM harness connector.
2. Also check harness for short to ground and short to power.
Is inspection result normal?
YES >> GO TO 4.
NO >> Repair or replace error-detected parts.
4.CHECK ENGINE OIL PRESSURE SENSOR
Refer to EC, "Component Inspection".
Is inspection result normal?
YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".
NO >> Replace engine oil pressure sensor. Refer to EM, "Exploded View".
1.CHECK ENGINE OIL PRESSURE SENSOR
Is the inspection result normal?
YES >> INSPECTION END.
NO >> Replace engine oil pressure sensor. Refer to EM, "Exploded View".
Description ECM controls ignition timing and engine idle speed when engine is started with prewarming up condition. This control promotes the activation of three way catalyst by heating the c ...
Final drive
Exploded View
1. Differential side bearing outer race 2. Differential side bearing 3. Final
drive
: Replace the parts as a set.
Disassembly
Remove differential side bearings, using Tool (A) and suitable tool.
Tool number : ST33052000 ( - )
Assembly
Install differential sid ...
Oil pan
Exploded View
1. Transaxle assembly 2. Oil pan gasket 3. Magnet
4. Oil pan 5. Overflow tube 6. Drain plug gasket
7. Drain plug 8. Oil pan fitting bolt
Removal and Installation
REMOVAL
Remove the drain plug and overflow tube, and then drain the CVT fluid.WARNING:
CVT fluid can splash ...