Nissan Versa (N17): P0713 Transmission fluid temperature sensor A

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P0713 Transmission fluid temperature sensor A

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P0713 Transmission Fluid Temperature Sensor A Circuit High The CVT fluid temperature identified by the TCM is −40C (−40F) or less continuously for 5 seconds or more under the following diagnosis conditions:

- Diagnosis conditions

- Ignition switch: ON

- Vehicle speed: More than 10 km/h (7 MPH)

- TCM power supply voltage: More than 11 V

 - Harness or connector (CVT fluid temperature sensor circuit is open or shorted to power supply)

- CVT fluid temperature sensor

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine.
  2. Maintain the following condition for 10 seconds or more.
  3. Stop the vehicle.
  4. Check the first trip DTC.

    Vehicle speed : 20 km/h (12 MPH) or more

Is "P0713" detected?

YES >> Go to TM "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT (PART 1)

  1. Turn ignition switch OFF.
  2. Disconnect TCM connector and CVT unit connector.
  3. Check continuity between TCM harness connector terminals and CVT unit harness connector terminals.

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace malfunctioning part.

2.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT (PART 2)

  1. Turn ignition switch ON.
  2. Check voltage between TCM harness connector terminal and ground.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace malfunctioning part.

3.CHECK CVT FLUID TEMPERATURE SENSOR

Check CVT fluid temperature sensor. Refer to TM "Component Inspection (CVT Fluid Temperature Sensor)".

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> Repair or replace malfunctioning parts.

Component Inspection (CVT Fluid Temperature Sensor)

1.CHECK CVT FLUID TEMPERATURE SENSOR

Check resistance between CVT unit connector terminals. 

Is the inspection result normal?

YES >> INSPECTION END

NO >> There is a malfunction of CVT fluid temperature sensor. Replace transaxle assembly. Refer to TM "Removal and Installation".

P0712 Transmission fluid temperature sensor A

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0712 Transmission Fluid Temperature Sensor A Circuit Low The CVT ...

P0715  Input speed sensor A

Other materials:

Unbalance steering wheel turning force (torque variation)
Description Unbalance steering wheel turning force (torque variation). Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT Turn the ignition switch OFF to ON. Perform "EPS" self-diagnosis. Is any DTC detected? YES >> Check the DTC. Refer to STC "DTC Index". NO & ...

Spiral cable
Exploded View 1. Steering column upper cover 2. Combination switch 3. Spiral cable 4. Steering wheel 5. Driver air bag module 6. Steering lock escutcheon 7. Steering column lower cover 8. Steering column assembly Pawl Removal and Installation WARNING: Always observe the following items f ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0051