Nissan Versa (N17): Panic alarm function does not operate

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Panic alarm function does not operate

Diagnosis Procedure

1.CHECK REMOTE KEYLESS ENTRY FUNCTION

Check remote keyless entry function.

Does door lock/unlock with Intelligent Key button?

YES >> GO TO 2.

NO >> Refer to DLK "Diagnosis Procedure".

2.CHECK HORN OPERATION

  1. Select IPDM E/R using CONSULT.
  2. Select HORN in ACTIVE TEST mode.
  3. Touch On to check that it works normally.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK PANIC ALARM SET SETTING IN WORK SUPPORT

  1. Select INTELLIGENT KEY of BCM.
  2. Select PANIC ALARM SET in WORK SUPPORT mode.
  3. Check PANIC ALARM SET setting in WORK SUPPORT.

Refer to BCS "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)".

Is the inspection result normal?

YES >> GO TO 4.

NO >> Set MODE 1 or MODE 3 in PANIC ALARM SET

4.REPLACE BCM

  1. Replace BCM. Refer to BCS "Removal and Installation".
  2. Confirm the operation after replacement.

Is the result normal?

YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI "Intermittent Incident".

Key id warning does not operate

Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC ind ...

Other materials:

Car phone or CB radio
When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts. WARNING A cellular phone should not be used for any purpose while driving so ...

Readiness for inspection/maintenance (I/M) test
Due to legal requirements in some states and Canadian Provinces, your vehicle may be required to be in what is called the "ready condition" for an Inspection/Maintenance (I/M) test of the emission control system. The vehicle is set to the "ready condition" when it is driven through certain d ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0064