Nissan Versa (N17): Key id warning does not operate

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Key id warning does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM

Check that DTC is not detected with BCM

Is the inspection result normal?

YES >> GO TO 2.

NO >> Perform trouble diagnosis relevant to DTC indicated.

2.CHECK DTC WITH COMBINATION METER

Check that DTC is not detected with combination meter

Is the inspection result normal?

YES >> GO TO 3.

NO >> Perform trouble diagnosis relevant to DTC indicated.

3.CHECK INTELLIGENT KEY

Check Intelligent Key.

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

  • Instrument center: Refer to DLK "DTC Logic".
  • Console: Refer to DLK "DTC Logic".
  • Trunk room: Refer to DLK "DTC Logic".

Is the inspection result normal?

YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CHECK KEY WARNING LAMP

Check key warning lamp.

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 6.

NO >> Repair or replace the malfunctioning parts.

6.REPLACE BCM

  1. Replace BCM. Refer to BCS "Removal and Installation".
  2. Confirm the operation after replacement.

Is the result normal?

YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI "Intermittent Incident".

Door lock operation warning does not operate

Diagnosis Procedure 1.CHECK DOOR LOCK FUNCTION Check door lock function. Does door lock/unlock using door request switch? YES >> GO TO 2. NO >> Refer to DLK "Diagnosis Procedur ...

Panic alarm function does not operate

Diagnosis Procedure 1.CHECK REMOTE KEYLESS ENTRY FUNCTION Check remote keyless entry function. Does door lock/unlock with Intelligent Key button? YES >> GO TO 2. NO >> Refer to DLK ...

Other materials:

Steering wheel
Tilt operation Push the lock lever 1 down and adjust the steering wheel up or down 2 to the desired position. Pull the lock lever 1 up to lock the steering wheel in place. WARNING Do not adjust the steering wheel while driving. You could lose control of your vehicle and cause an accid ...

P0705 Transmission range switch A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0705 Transmission Range Sensor "A" Circuit Malfunction (PRNDL input) The following diagnosis conditions are met and 2 or more position signals are ON at the ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0107