Diagnosis Procedure
1.CHECK DOOR LOCK FUNCTION
Check door lock function.
Does door lock/unlock using door request switch?
YES >> GO TO 2.
NO >> Refer to DLK "Diagnosis Procedure".
2.CHECK INTELLIGENT KEY WARNING BUZZER
Check Intelligent Key warning buzzer.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.REPLACE BCM
Is the result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI "Intermittent Incident".
Intelligent key low battery warning
does not operateDiagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC indic ...

Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC ind ...
P0607 ECM
DTC Logic
DTC DETECTION LOGIC
DTC No.
Trouble diagnosis
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0607
ECM
(CAN communication bus)
When detecting error during the initial diagnosis
of CAN controller of ECM.
ECM
DTC CO ...
Intake door cable
INTAKE DOOR CABLE : Removal and Installation
REMOVAL
Remove instrument panel assembly. Refer to IP "Removal and
Installation".
Disconnect intake door cable from A/C control.
Disconnect intake door cable from A/C unit assembly and remove.
INSTALLATION
Installation is in the ...