Inspection
1.CHECK IGNITION TIMING
1. Attach timing light (A) to loop wire (1) as shown.

2. Check ignition timing.
1 : Timing indicator
>> INSPECTION END

IDLE SPEEDInspection 1.CHECK IDLE SPEED With CONSULT Check idle speed in "DATA MONITOR" mode with CONSULT. Without CONSULT Check idle speed by installing the pulse type tachometer clamp on the loop wir ...

Inspection 1.CHECK EVAP CANISTER Block port (B). Blow air into port (A) and check that it flows freely out of port (C). Release blocked port (B). Apply vacuum pressure to port (B) and check ...
Evaporative emission system
EVAPORATIVE EMISSION SYSTEM : System Diagram
EVAPORATIVE EMISSION SYSTEM : System
Description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Camshaft position sensor (PHASE)
Engine speed*1
Piston ...
Main power supply and ground circuit
Diagnosis Procedure
1.CHECK TCM POWER CIRCUIT 1
Turn the ignition switch OFF.
Disconnect the TCM connector.
Check the voltage between the TCM harness connector terminals and
ground.
Is the inspection result normal?
YES >> GO TO 2.
NO >> GO TO 4.
2.CHECK TCM POWER ...