Nissan Versa (N17): Evaporative emission system

Inspection

1.CHECK EVAP CANISTER

  1. Block port (B).
  2. Blow air into port (A) and check that it flows freely out of port (C).
  3. Release blocked port (B).
  4. Apply vacuum pressure to port (B) and check that vacuum pressure exists at the ports (A) and (C).
  5. Block port (A) and (B).
  6. Apply pressure to port (C) and check that there is no leakage.

CHECK EVAP CANISTER

>> INSPECTION END

Ignition timing

Inspection 1.CHECK IGNITION TIMING     1.   Attach timing light (A) to loop wire (1) as shown.     2.   Check ignition timing. 1 : Timing in ...

EVAP leak check

Inspection CAUTION: Do not use compressed air or a high pressure pump. Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: Do not start engine. Improp ...

Other materials:

Windows
Power windows (if so equipped) WARNING Make sure that all passengers have their hands, etc. inside the vehicle while it is in motion and before closing the windows. Use the window lock switch to prevent unexpected use of the power windows To help avoid risk of injury or death thr ...

Drive belt
1. Water pump pulley 2. Generator pulley 3. Manual tensioner pulley 4. Air conditioner compressor pulley 5. Crankshaft pulley WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. 1. Visually inspect t ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0065