Nissan Versa (N17): IDLE SPEED

Inspection

1.CHECK IDLE SPEED

With CONSULT

Check idle speed in "DATA MONITOR" mode with CONSULT.

Without CONSULT

Check idle speed by installing the pulse type tachometer clamp on the loop wire or on suitable high-tension wire which installed between No.1 ignition coil and No.1 spark plug.

With GST

Check idle speed with Service $01 of GST.

>> INSPECTION END

Normal operating condition

Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,400 rpm under no load (for example, the shift lever position is neutral and engine speed is over 2 ...

Ignition timing

Inspection 1.CHECK IGNITION TIMING     1.   Attach timing light (A) to loop wire (1) as shown.     2.   Check ignition timing. 1 : Timing in ...

Other materials:

Position switch
Removal and Installation REMOVAL Drain gear oil. Refer to TM, "Draining". Disconnect the harness connector (A) from position switch. Remove position switch from transaxle case. INSTALLATION Apply recommended sealant to threads of position switch.    &nbs ...

U1258 Satellite radio antenna
DTC Logic DTC DETECTION LOGIC    Diagnosis Procedure Regarding Wiring Diagram information, refer to AV "Wiring Diagram". 1.SATELLITE ANTENNA INSPECTION Visually inspect the satellite antenna and antenna feeder. Refer to AV "Feeder Layout". Is inspection r ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0097