Removal and Installation
REMOVAL

INSTALLATION
CAUTION:
- Use Genuine Silicone RTV or equivalent. Refer to GI, "Recommended Chemical Products and Sealants".
- Remove old sealant and oil adhering to threads.
Inspection
INSPECTION AFTER INSTALLATION
Side oil sealRemoval and Installation REMOVAL Remove front drive shaft from transaxle assembly. Refer to FAX, "Removal and Installation". Remove differential side oil seal (1) using suitable to ...

Exploded View 1. Shifter lever A 2. Selector lever 3. Selector cable 4. Shifter cable 5. Cable mounting bracket 6. Tapping bolt 7. Bracket 8. Grommet 9. M/T shift selector assembly 10. Shift s ...
P0717 Input speed sensor A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0717
Input/Turbine Speed Sensor "A"
Circuit No Signal
Under the following diagnosis
conditions, the input speed sensor
value is less than 600 rpm
continuousl ...
P0733 3GR Incorrect ratio
Description
This malfunction is detected when the A/T does not shift into 3GR position as
instructed by TCM. This is not
only caused by electrical malfunction (circuits open or shorted) but by
mechanical malfunction such as control
valve sticking, improper solenoid valve operation, etc.
DTC ...