AIR BAG Warning Lamp Does Not Turn Off
1.CHECK CONDITION OF AIR BAG MODULE
Inspect for any deployed air bag modules or seat belt pre-tensioners.
Are any air bag modules or seat belt pre-tensioners deployed?
YES >> Refer to SR "For Frontal Collision" or SR "For Side and Rollover Collision".
NO >> GO TO 2
2.CHECK THE AIR BAG FUSE
Check 10A fuse [No. 7, located in the fuse block (J/B)].
Is the fuse blown?
YES >> GO TO 3
NO >> GO TO 4
3.CHECK AIR BAG FUSE AGAIN
Replace 10A fuse [No. 7, located in the fuse block (J/B)] and turn ignition switch ON.
Does the fuse blow again?
YES >> Replace fuse and harness.
NO >> Inspection End.
4.CHECK AIR BAG DIAGNOSIS SENSOR UNIT
Connect CONSULT.
Is "AIR BAG" displayed on CONSULT?
YES >> GO TO 5
NO >> Visually inspect the air bag diagnosis sensor unit harness connections. If the connections are OK, replace the air bag diagnosis sensor unit. Refer to SR "Removal and Installation".
5.CHECK HARNESS CONNECTION
Check for loose connections between the combination meter and the air bag diagnosis sensor unit.
Are there any loose connections?
YES >> Properly connect the combination meter and air bag diagnosis sensor unit harness connectors. If AIR BAG warning lamp still does not turn off, replace the wiring harness.
NO >> Replace air bag diagnosis sensor unit. Refer to SR "Removal and Installation".
SRS Air bag warning lamp does not
turn onAIR BAG Warning Lamp Does Not Turn On 1.CHECK METER FUSE Check the 10A fuse [No. 3, located in the fuse block (J/B)]. Is the fuse blown? YES >> GO TO 2 NO >> GO TO 3 2.REPLACE METER ...

Seat Belt Warning System Does Not Function 1.SEAT BELT WARNING LIGHT Turn ignition switch ON. Does the seat belt warning lamp come ON? YES >> GO TO 2 NO >> Check 10A fuse [No. 3, ...
Shift control
SHIFT CONTROL : System Description
SYSTEM DIAGRAM
DESCRIPTION
To select the gear ratio that can give the driving force to meet driver's
intent or vehicle situation, the vehicle
driving condition such as vehicle speed or accelerator pedal position is
detected and the most appropriate
g ...
G Sensor
Exploded View
1. G sensor
Front
Removal and Installation
CAUTION:
Do not drop or strike G sensor, because it may be damaged by
impact.
Do not use a power tool.
REMOVAL
Disconnect the battery negative terminal. Refer to PG "Removal and
Installation".
Remov ...