Description
Light reminder warning chime does not sound even though headlamps are illuminated.
Diagnosis Procedure
1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION
Check that the headlamps operate normally by operating the combination switch (lighting switch).
Do they operate normally?
YES >> GO TO 2.
NO >> Refer to WCS "Work Flow".
2.CHECK DRIVER SIDE DOOR SWITCH SIGNAL CIRCUIT
Perform the check for the driver side door switch signal circuit. Refer to DLK "Diagnosis Procedure" (with Intelligent Key) or DLK "Diagnosis Procedure" (without Intelligent Key).
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace harness or connector.
3.CHECK DRIVER SIDE DOOR SWITCH
Perform a unit check for the driver side door switch. Refer to DLK "Component Inspection" (with Intelligent Key) or DLK "Component Inspection" (without Intelligent Key).
Is the inspection result normal?
YES >> Replace the BCM. Refer to BCS "Removal and Installation" (with Intelligent Key) or BCS "Removal and Installation" (without Intelligent Key).
NO >> Replace driver side door switch. Refer to DLK "Removal and Installation" (with Intelligent Key) or DLK "Removal and Installation" (without Intelligent Key).
The seat belt reminder warning
continues sounding, or does not
soundDescription Seat belt reminder warning does not sound. Seat belt reminder warning sounds continuously. Diagnosis Procedure NOTE: To identify combination meter type, refer to MWI "Infor ...

Description The key warning chime does not sound, when all of the following conditions are fulfilled. Key inserted into the key cylinder (key switch signal ON). Ignition switch is in ACC or O ...
Noise, vibration and harshness (NVH) troubleshooting
NVH troubleshooting Chart
Locate the area where noise occurs.
Confirm the type of noise.
Specify the operating condition of engine.
Check specified noise source
If necessary, repair or replace these parts.
Location
of noise
Type of
noise
Operating condition of
...
Accelerator control system
Exploded View
1. Accelerator pedal assembly 2. Brake pedal bracket A. Locating hook
B. Locating pin
Removal and Installation
CAUTION:
Do not disassemble accelerator pedal assembly. Do not remove
accelerator pedal position sensor
from accelerator pedal assembly.
Avoid impact from ...