Nissan Versa (N17): Trunk lamp switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lamp switch

Description

Detects trunk open/close condition.

Component Function Check

1.CHECK FUNCTION

With CONSULT

Check TRNK/HAT MNTR in Data Monitor mode with CONSULT.  

Is the inspection result normal?

YES >> Trunk room lamp switch is OK.

NO >> Refer to DLK "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".

1.CHECK TRUNK ROOM LAMP SWITCH INPUT SIGNAL

  1. Turn ignition switch OFF.
  2. Check voltage between BCM connector and ground.               

Is the inspection result normal?

YES >> GO TO 6

NO >> GO TO 2

2.CHECK TRUNK ROOM LAMP SWITCH CIRCUIT

  1. Disconnect BCM and trunk room lamp switch connector.
  2. Check continuity between BCM connector and trunk room lamp switch connector.
  3. Check continuity between BCM connector and ground.  

Is the inspection result normal?

YES >> GO TO 3

NO >> Repair or replace harness between BCM and trunk room lamp switch.

3.CHECK TRUNK ROOM LAMP SWITCH GROUND CIRCUIT

Check continuity between trunk room lamp switch connector and ground.  

Is the inspection result normal?

YES >> GO TO 4

NO >> Repair or replace trunk room lamp switch ground circuit.

4.CHECK BCM OUTPUT SIGNAL

  1. Insure trunk lid remains closed during this step.
  2. Connect BCM connector.
  3. Check voltage between BCM connector and ground. 

Is the inspection result normal?

YES >> GO TO 5

NO >> Replace BCM. Refer to BCS "Removal and Installation".

5.CHECK TRUNK ROOM LAMP SWITCH

Refer to DLK "Component Inspection".

Is the inspection result normal?

YES >> GO TO 6

NO >> Replace trunk room lamp switch.

6.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

Component Inspection

1.CHECK TRUNK ROOM LAMP SWITCH

  1. Turn ignition switch OFF.
  2. Disconnect trunk room lamp switch connector.
  3. Check trunk room lamp switch.                                                   

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace trunk room lamp switch.

SYMPTOM DIAGNOSIS

Other materials:

Ignition timing
Inspection 1.CHECK IGNITION TIMING     1.   Attach timing light (A) to loop wire (1) as shown.     2.   Check ignition timing. 1 : Timing indicator >> INSPECTION END ...

Stall test
Work Procedure INSPECTION Check the engine oil level. Replenish if necessary. Check for leak of the CVT fluid. Refer to TM "Inspection". Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80C (122 to 176F). Be sure to apply the par ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0058