Nissan Versa (N17): Trunk lid opener cable

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid opener cable

TRUNK LID OPENER CABLE : Removal and Installation

REMOVAL

1. Remove trunk lid striker. Refer to DLK "TRUNK LID STRIKER : Removal and Installation".

2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation".

3. Remove rear seat cushion. Refer to SE "Removal and Installation - Seat Cushion Assembly".

4. Remove center pillar lower finisher (LH). Refer to INT "CENTER PILLAR LOWER FINISHER : Removal and Installation".

5. Remove trunk lid opener handle. Refer to DLK "TRUNK LID OPENER HANDLE : Removal and Installation".

6. Release pawl using a suitable tool (A) and open the harness clip.

: Pawl

REMOVAL

7. Remove trunk lid opener cable.

CAUTION: Use care not to damage the trunk lid opener cable when removing.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • After installation, check trunk lid open/close, lock/unlock operation.
  • After installation, perform the trunk lid adjustment procedure. Refer to DLK "TRUNK LID ASSEMBLY : Adjustment".

EMERGENCY LEVER

EMERGENCY LEVER : Removal and Installation

Removal

1. Release the pawls using a suitable tool and remove emergency release handle (1) from trunk lid assembly.

: Pawl

2. Disconnect emergency release handle cable (2) from trunk lid lock assembly (3).

Removal

FUEL FILLER LID OPENER

Exploded View

Exploded View

1. Fuel filler lid opener cable 2. Spring 3. Fuel filler lid assembly 4. Bumper rubber 5. Fuel filler lid lock assembly 6. Cable protector Clip

FUEL FILLER LID

FUEL FILLER LID : Removal and Installation

REMOVAL

1. Fully open fuel filler lid.

2. Remove fuel cap pin (1).

REMOVAL

3. Remove fuel filler lid screws and fuel filler lid.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, check fuel filler lid assembly open/close, lock/unlock operation.

Trunk lid opener handle

TRUNK LID OPENER HANDLE : Removal and Installation REMOVAL 1. Remove front kicking plate (LH). Refer to INT "KICKING PLATE INNER : Removal and Installation". 2. Disengage pawl using a s ...

Fuel filler opener cable

FUEL FILLER OPENER CABLE : Removal and Installation REMOVAL 1. Remove hood and fuel filler handle assembly bolts (A). 2. Disconnect fuel filler lid opener cable (2) by pulling downward and th ...

Other materials:

When traveling or registering in another country
When planning to drive your NISSAN vehicle in another country, you should first find out if the fuel available is suitable for your vehicle's engine. Using fuel with an octane rating that is too low may cause engine damage. All gasoline vehicles must be operated with unleaded gasoline. There ...

Owner's Manual/Service Manual order information
Genuine NISSAN Service Manuals for this model year and prior can be purchased. A Genuine NISSAN Service Manual is the best source of service and repair information for your vehicle. This manual is the same one used by the factorytrained technicians working at NISSAN dealerships. Genuine NI ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.005