Nissan Versa (N17): Fuel filler opener cable

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Fuel filler opener cable

FUEL FILLER OPENER CABLE : Removal and Installation

REMOVAL

1. Remove hood and fuel filler handle assembly bolts (A).

REMOVAL

2. Disconnect fuel filler lid opener cable (2) by pulling downward and then sliding cable end to the side to remove from hood and fuel filler handle assembly (1).

REMOVAL

3. Remove dash side finisher (LH). Refer to INT "DASH SIDE FINISHER : Removal and Installation".

4. Remove center pillar lower finisher (LH). Refer to INT "CENTER PILLAR LOWER FINISHER : Removal and Installation".

5. Remove trunk side finisher (LH). Refer to INT "Removal and Installation".

6. Remove fuel filler lid opener cable from fuel filler lid lock assembly. Refer to DLK "FUEL FILLER LID LOCK : Removal and Installation".

7. Disengage each harness protector (1), and then remove fuel filler lid opener cable (2).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, check fuel filler lid assembly open/close, lock/unlock operation.

Trunk lid opener cable

TRUNK LID OPENER CABLE : Removal and Installation REMOVAL 1. Remove trunk lid striker. Refer to DLK "TRUNK LID STRIKER : Removal and Installation". 2. Remove trunk side finisher (LH). R ...

Fuel filler lid lock

FUEL FILLER LID LOCK : Removal and Installation REMOVAL 1. Fully open fuel filler lid. 2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation". ...

Other materials:

Seats
WARNING Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against your body. In an accident, you could be thrown into it and receive neck or other serious injuries. You could also slide under the lap belt and recei ...

Rear oil seal
REAR OIL SEAL : Removal and Installation REMOVAL Remove transaxle assembly. Remove clutch cover and clutch disk (M/T models). Remove flywheel (M/T models) or drive plate (A/T or CVT models). Remove rear oil seal with a suitable tool. CAUTION: Be careful not to damage crankshaft an ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0075